Tyan-computer Barebone System B4881V50S4H Manuale Utente Scaricare il pdf (Pagina 37)

2.5 Standalone

Chapter 2: Setting up 29

2.5 Standalone

The B4881V50S4H can be used as a standalone device

when fitted with the plastic feet in the accessory pack. When

used as a standalone device, the feet must be fitted to pre-

vent the unit from falling over.

The four feet should be attached as follows:

1. Each foot consists of two pieces. Insert the round piece

of the foot into the other foot section. The small plastic

tab on the round piece should fit into the curved slot on

the other piece.

2. Use a single screw through the center of the round sec-

tion to fasten the foot assembly to the bottom of the chas-

sis. The plastic tab that protrudes through the curved slot

should fit into an indent in the chassis case.

When fitted, each foot should rotate about 90°.

3. Fit all four feet in the same way.

Curved slot

Tab fits in curved slot

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Nessun commento

Tyan-computer Barebone System B4881V50S4H Manuale Utente Pagina 37